How to renovate the iron pipe chair can be done in four simple steps.

The iron pipe chair at home is broken. Do you have any experience in renovating it? In fact, it is often just the parts that are broken, and the iron bracket is still good. It would be a pity to throw it away. So how to renovate the iron pipe chair? Let's take a look at Zhao Bin decoration. Four steps can make a broken chair look brand new.

Tools used for chair renovation:

1, air compressor, nail gun, code nail, electric welding machine, electric drill, nail gun, wrench.

2, leather, interlining, yards

The first step of chair renovation:

First, remove all the chairs, remove the handrails with a wrench and loosen the nuts. Then weld the welded place again, and it must be welded on the spot. After welding, rusty areas can be cleaned, polished and painted. Before disassembly, the seat surface and backrest edge of the chair are covered with a circle of rubber. Open the hemming from the back, slowly tilt the hemming nail with a screwdriver and pull it out with pliers. Be sure not to forcibly pull it, and use it to seal the edge after it is done.

Chair renovation step 2:

For chairs that have been used for a long time, plastic mats are generally worn out and can no longer be used. I use leather as a mat, which is elastic, wear-resistant and won't scratch the ground. Wrap the leather, cut it, make the overlap as long as possible, then fix the hole, and then fix it with a gun.

The third step of chair renovation:

Remove the chair surface and the sponge inside will be exposed. Clean the sponge and try to make up the missing part. Then, according to its shape, draw the leather and cut it into as large a size as possible. Then, first, stretch the front leather and carefully fix it with a nail gun, with even use and flat corners. After completion, cut the backing in turn and fix it with nails along the edge. This circle must be close to the edge. Finally, the edge can be sealed. Before edge sealing, first find the invisible middle seam, make a circle, and then start fixing. Not too close. Touch the edge with your hands when fixing, and don't nail it inside or too outside. Noodles are ready. Most of the work will be ready.

The fourth step of chair renovation:

Finally, start the installation. First, install the seat cushion, carefully find the screw hole of the seat cushion, check it by hand, and then poke it with a screwdriver. Pay attention to the front and back direction. Then walk to the handrails on both sides, and finally put on the cushion. Don't worry when you go up, because you can't see the screw holes, so be careful. It is convenient to use hexagon screws as far as possible. Especially the screw in the handrail groove, other screws can not be condensed.

Do you think it is economical and practical after reading the above transformation steps of the iron pipe chair? In fact, as long as you master the appropriate methods, you can turn waste into treasure and keep your home life away from waste.