Where is the Chevrolet Cruze engine control module?

The engine control module of Chevrolet Cruze is on the right side of the gearbox. Engine is a machine that can convert other forms of energy into mechanical energy, including internal combustion engine (reciprocating piston engine) and external combustion engine (Stirling engine, steam engine, etc.). ), jet engines, motors, etc. The working mode of the engine control module is as follows: 1. Start mode. After the ignition switch is turned on, the engine control module (ECM) energizes the fuel pump relay for 2 seconds, thus establishing oil pressure in the fuel system. Then, the ECM checks the engine coolant temperature (ECT) sensor and the throttle position (TP) sensor to prepare for starting. 2. Clear the oil leakage pattern. If the engine leaks oil (flooding the cylinder), press the accelerator pedal to the bottom and start the engine. The engine control module (ECM) will control the fuel injector not to inject fuel to remove the accumulated oil in the cylinder; 3. Operation mode. There are two modes of operation, namely, open loop and closed loop. When the engine has just started, the engine temperature does not reach the specified value, and the speed is above the predetermined speed, the system will work in the open-loop state; 4. Acceleration mode: When the accelerator pedal is depressed, the air flow into the cylinder increases rapidly, and the ECM increases the pulse width of the fuel injector and increases the fuel injection quantity. The fuel demand is determined according to throttle position (TP), coolant temperature (ECI), intake manifold pressure (MAP) sensor and engine speed, and the system is temporarily in an open-loop operation state. 5. Deceleration mode: In deceleration fuel mode, the engine control module (ECM) enters the open-loop control state, reducing the pulse width of fuel injector and fuel supply, thus reducing emissions and fuel consumption and increasing engine braking.