The difference between eight-character warehousing and outbound

In the b2 subject 2 exam, reversing the big truck into the warehouse, that is, the "pile test", should be the most difficult one for everyone. Maybe some car owners who have been driving for a long time still have an impression, because a long time ago, the pile test was actually one of the second exams of automobile subject, but it was later cancelled.

"eight-character formula for reversing storage"

The starting position is very important, and the low-speed starting is more reliable;

Choose a good reference to turn and correct it in time.

Start slowly and turn quickly, and call back at the right time;

Don't worry on the way back, remember to control the speed;

Don't turn too much, the rear direction is very important;

Once again, it is slightly modified, taking into account the rear of both sides;

Pay attention to the same when leaving the library, and adjust the parking position;

Look at the main pole to find the right time, grasp the direction late and early;

Keep turning around the main pole, and the front wheel of the car is straight down.

To put it simply, the running route of reversing warehousing is to pour into warehouse B from the starting point and stop, then return to warehouse A twice, then enter the control line from warehouse B, pour into warehouse A and stop, and then go back to the starting point. Vehicles shall not stop on the way forward and backward, and the running time shall not exceed 8 minutes.

"Detailed Rules for Step-by-Step Reversal and Storage"

First, stop library B.

1. The truck stops at the starting line, and the left side of the car body keeps a distance of about 1.5- 1.8m from the depot line. When you get on the bus, the steering wheel will not move backwards. Look back from the right rearview mirror. When the second boom in front of the trunk board is aligned with the second lever, turn the steering wheel all the way to the right.

2. Continue to observe the right rearview mirror. When the third sunshade rod is aligned with the second rod behind the trunk board, turn the steering wheel back to the left appropriately and keep the distance between the trunk board and the second rod about 20 cm.

3. After the truck is put into storage, it descends vertically, so that the carriage plate is located between four or five poles, and the direction is corrected in time, so that it can be played quickly, retreated quickly, played less and retreated less. After driving to the carriage board, stop when the middle position of the first and second awning poles is aligned with the five poles.

Second, advance for the first time

1, gradually hit the direction after starting, and hit while walking. Pay special attention to the fact that if you hit the direction too fast at this time, it will be easy for the rear car to go out of the pile line at the corner. When you come out about 3 meters, turn right to the steering wheel.

2. When the seat is aligned with the middle two rods, continue to push the steering wheel to the left.

3. When the distance from the sideline is about 80- 100 cm, turn back to the positive direction and stop quickly.

Third, after the second fall

1. Turn the steering wheel to the right after starting.

2. Looking back, when the middle position of the rear compartment plate is aligned with the sixth lever, quickly turn the steering wheel to the left.

3. When the car body is parallel to the garage, turn around, stand upright and then fall back.

4. When the rear of the car is about 80- 100 cm from the fifth pole, stop in the opposite direction.

Fourth, the second push

1. Turn to the right according to the vehicle position, keep the midpoint of the front of the car aligned with roof of the world, and turn gradually at the front of the car.

2. When the bumper is about 2-2.5 meters away from the front, quickly turn the steering wheel to the left and straighten the vehicle.

3. When the bumper is about 0.8- 1 m away from the second and third poles, stop quickly in the opposite direction.

After the fall of the fifth and third years, I moved to the library.

According to the position of the car body, turn right appropriately. Looking back, the car board is in the middle of five or six bars and then falls down. When the rear of the car approaches five or six strokes, stop the car straight.

Sixth, advance for the third time, diagonally cross the library B to the main road.

1. Turn left quickly after starting, and let the front of the car move forward between the first and second poles.

2. When the rear of the car is close to the full exit, quickly turn the steering wheel to the left to the end, drive to the front of the finish line 1 m and stop in the backward direction.

Seven, pour into a library.

1. Turn the steering wheel when you don't move, and look back from the left rearview mirror. Turn the steering wheel to the left when the second boom in front of the trunk board is aligned with the second lever.

2. Continue to observe the left rearview mirror. When the third boom is aimed at the second pole behind the trunk board, properly turn the steering wheel back to the right, and keep the distance between the trunk board and the second pole at about 20km.

3. After entering the A store, look back at the fifth and sixth poles, so that the carriage board is located in the middle.

Eight, back to the starting point

When the front of the car enters the garage, stop in the opposite direction and drive the car back to the starting position. Note that when the rear of the car leaves the garage, turn the steering wheel to the right quickly, and the front wheel just hits the dotted line on the roadside and stops before reaching the starting line.

Evaluation criteria:

1, not driving in the prescribed route order, unqualified;

2. Not completely dumped into the warehouse, which is unqualified;

3. If the car body does not conform, it is unqualified;

4. Stop halfway or run for more than the specified time, which is unqualified.