Can it be done by adding plugging agent to the automobile water tank? Are there any shortcomings?

Disadvantages of adding plugging agent to automobile water tank leakage;

1, the plugging agent will solidify in the narrow part of the waterway, blocking the waterway and the inside of the water tank;

2. The impurities in the water tank waterway will directly cause the water tank to be blocked and damaged;

3. At first, it may cause problems such as the warm air is not hot, and the heat dissipation of the water tank is not good. After a long time, it will gradually cause poor circulation, and sometimes the water temperature is too high to form a complete circulation.

Extended data:

Treatment of water leakage in automobile water tank;

1. If the water tank leaks, immediately check whether the water tank cover is fastened!

2. If it is confirmed that the water tank cover is fastened, but there is still water leakage, please check whether the water tank is leaking. This requires filling the water tank with air, pressurizing the water in the water tank, and checking the specific leakage point of the vehicle!

3. If the leakage point is a crack or hole with a diameter of less than 2mm, you can add a bottle of strong water tank plugging agent to the water tank at this time, and then start the car. When the cooling water circulates for 5- 10 minutes, no matter whether the water tank or hose in the cooling system leaks everywhere before, it will stop now, and the water will not leak out again, and there will be no blockage and thermal effect!