Geothermal solar terms

It's more fuel efficient to drive 24 hours a day.

Reason: turning off and turning on again means starting all over again. Because there is a big difference between room temperature and boiler set temperature, more gas will be wasted.

So before going out, you just need to set the thermostat to the energy-saving temperature (12- 16℃). At this time, the boiler is in a low temperature insulation state, the circulating water temperature is kept between 35-40℃, and the overall indoor space temperature is about 12- 16℃. When you come back, the boiler will be very hot.

Extended data:

Precautions for floor heating:

1, heating should be gradual when it is used for the first time.

When using geothermal floor, slowly heat the floor and floor. During installation, the surface temperature should be kept at about 65438 08℃. It is necessary to gradually heat the cement floor and increase it by 5℃ every day until it reaches 18℃.

2, the surface temperature should not be too high

When geothermal heating is used, the surface temperature should not exceed 28℃, and the water pipe temperature should not exceed 45℃. If it exceeds this temperature, it will affect the service life and service cycle of the floor. The average family is comfortable when the room temperature reaches about 22℃ in winter. If the temperature rises normally, it will not affect the use of geothermal floor.

References:

Baidu encyclopedia-floor heating