Correct operation method and matters needing attention in using fishing rod

1. When using fishing rods in sequence, unplug the plugs first and pull out the fishing rods one by one from the top in sequence. When pulling out, the strength should be consistent, and the joint of each rod segment should be slightly tightened without leaving gaps, so that the force on the rod can be uniform, the overall elasticity of the rod can be fully exerted, and the rod can be prevented from cracking. After fishing, you should start from the handle and collect the rod from coarse to fine. When closing the pole, don't use your hands too hard. Hold the last paragraph with your left hand and the next paragraph with your right hand, and twist it gently in two different directions.

2. The combination of fishing rod and fishing line ties the fishing line in a double knot and puts it on the "snake letter" at the tip of the rod, instead of using the old method of connector to entangle the fishing group when the rod is hands-free, which is time-consuming and laborious.

3. Taboo in using fishing rod: It is forbidden to soak the fishing rod in water during use, otherwise it will easily cause the rod to swell and the rod will not be put away. During the fishing break, the fishing rod should be placed on the bracket and cannot be thrown away at will to prevent others from breaking or stepping on it.

4. Precautions for using fishing rod: When there are wires or thunderstorms in the air, you should change the fishing point or go to a safe place to avoid rain, so as to avoid electric shock and casualties. After the big fish is hooked, when walking the fish, the fishing rod should be hit 90 degrees above the water surface to increase the elasticity and toughness of the fishing rod. When the fish is not tired, it is forbidden to copy the fish with a pole. After fishing, the fishing rod should be opened in time, and the residual bait and dust stuck on the rod body should be washed with clear water to avoid pulling the rod body out of the scar. After drying, wipe the oil on the guard rod in time for the next use. If you can't pick up the pole because the connection is too tight, you can take it home and give it to a professional.