What are the most detailed usage methods and precautions of Feng Shui compass?
2. Slide the turntable so that the hairpin head of the magnetic needle coincides with two points on the red line of the compass base.
3. Locate the reading direction of the layer pressed by the transparent line. For example, measure the direction of the furnace: keep the compass level and close to the edge of the furnace. If the furnace is made of iron, it will affect the swing of the magnetic needle, so it needs to move back two or three feet vertically. When the edge of the compass is parallel to the edge of the stove, slide the turntable so that the hairpin head of the magnetic needle coincides with the two points of the red line, and the direction can be read.
4. How to use the Feng Shui compass: When using the compass, hold the outer board with both hands left and right, and separate your feet slightly. Put the compass between the chest and abdomen, keep the compass level, and don't let it go up and down, or go up and down first. Then lie on your back, face to face, and start to stand upright.
5. At this time, the crosshair on the compass should coincide with the front, back, left and right positions of the house. If the crosshair is set incorrectly, the positioning direction of the measurement will deviate. After fixing the position of the cross fish, move the inner plate with two thumbs. When the inner disk rotates, Tianchi will also rotate with it. Turn the inner disk until the magnetic needle is stationary and coincides with the red line of Tianchi.
6. It is very important that the end of the magnetic needle with a small hole must coincide with the two little red dot on the red line, and the positions cannot be offset from each other. At this time, the fishing line in the sitting direction (that is, horizontal) intersects with each layer of the inner disk. All kinds of data and information we are looking for are displayed in the area where this fishing line passes and covers.
7. Precautions for the use of Feng Shui compass: You must first put all ironware, electrical appliances (mobile phone, walkman, ...) or objects that will interfere with the magnetic field of the compass. Be careful not to have ironware, mobile phones, telephone poles, electric boxes, electric towers, etc. It will interfere with the electromagnetic field near the measuring position.
8, compass or guide (north) dial must be horizontal, the pointer should not rise and fall at the same time. At the same time, we should pay attention to whether the joint between the compass surface and the disk body is tight, and there can be no looseness and cracks.
9. Check whether the compass or guide needle is normal, and don't use it when bending.