Scale of Rex Rabbit Breeding Base in Fengshuiliang

1. Topography

Should choose in dry terrain, sunny lee, flat or slightly sloping place (3 ~ 65438 00%),

water table

Low (1.5 ~ below 2.0m), good drainage and wide space are preferred. Such as low-lying, poor drainage, cool places, not suitable for building rabbit houses, because germs and parasites are easy to breed. The terrain is too high, which is vulnerable to cold wind in winter, and it is not conducive to the environmental control of rabbit houses and the health of rabbits in winter.

2. Water source

There must be a water source with sufficient water and good water quality. In order to ensure drinking water for people and animals,

Domestic water use

And the need for cleaning and disinfection of rabbit houses.

3. Land

Preferably sand. Because of its good water permeability, it can keep dry;

conductivity for heat

Low, with good thermal insulation performance. Loess and clay are the least ideal. I got wet in a big mess and did a knife. In this kind of soil, slate or cement foam is used.

Step 4: Location

It should be built in a quiet and sanitary place, so as to reduce the spread of diseases. If it should be 200 meters away from the traffic trunk line, it should be 200 meters away from the general road 100 meters; 200 meters away from residential areas, and in the downwind direction of residential areas and downwind direction of residents' drinking wells to prevent odor from blowing into residential areas and rabbit farms to pollute water sources; Should stay away from it.

slaughter house

, livestock markets, livestock products processing plants and places frequented by livestock to prevent

infectious disease

. At the same time, considering that there may be nearby

High voltage wire

Pass, convenient power supply.

5. Area and topography

When choosing a site, we should not only consider saving land but also leave room for development. Generally, a basic female rabbit and its offspring can be calculated according to the construction area of 0.6 square meters, and the rabbit farm

Building coefficient

Generally, it is 15% (the building coefficient refers to the percentage of all buildings in the total area within the construction land).

Then according to the number of basic female rabbits in the rabbit farm, the total area required for the rabbit farm can be calculated.

In addition, we can consider building rabbit farms, fish ponds and biogas digesters to feed fish with rabbit manure and surplus forage. Or send rabbit manure into biogas digester, which can not only produce biogas and provide heat for rabbit farm, but also reduce the pollution of bacteria and parasitic eggs in feces to the environment.