Introduction of installation methods of several brands of Eagle brand bathroom

There are too many bathroom brands on the market now, and many consumers feel confused when choosing, because they don't know which brand to choose. I have probably heard of the name Eagle brand bathroom, but the quality of other aspects should not be very clear. Next, let's see which brand Eagle brand bathroom belongs to. By the way, learn about the installation method of the bathroom.

1, which brand does Eagle brand bathroom belong to?

Which brand does Eagle brand bathroom belong to? It is understood that Eagle brand sanitary ware is a domestic first-line brand, second only to Kohler in the United States and TOTO in Japan, with high cost performance and exquisite workmanship. In addition, the sanitary ware produced by Eagle brand bathroom is very textured, with uniform coating and thick visual sense; It also has high-strength anti-corrosion and wear-resistant functions, and the surface color is like a mirror.

2. Installation method of Eagle brand bathroom

(a) Take out the pipe plug of the ground sewer pipe, check whether there are sundries in the pipe, then clean the periphery of the pipe orifice, then align the water outlet of the toilet with the pipe orifice of the sewer pipe, straighten it, draw a mark on the bolt hole of the toilet, and remove the toilet. Aim at the center of the rear tail of the toilet, draw a vertical line, draw a horizontal line at a height of 800 mm from the ground, draw a mark on the horizontal line according to the position of the two side holes on the back of the water tank, and make a hole with a diameter of 30 mm and a depth of 70 mm at the printed hole.

(b) Insert a bolt with a diameter of 65,438+00 mm and a length of 65,438+000 mm into the hole and tighten it with cement. Hang the back water tank on the bolt and align it evenly, especially with the center of the toilet. Put a rubber pad on the bolt and screw on the nut until it is moderately elastic.

(c) Make a hole with a diameter of 20 mm and a depth of 60 mm at the mark, insert a bolt with a diameter of 10 mm into the hole, screw it firmly with cement, put the toilet eye on the bolt to match the mark, and remove the toilet after the test. Apply putty around the water outlet and sewer of the toilet, then align the four bolt holes of the toilet with the bolts, align them evenly, cover the bolts with rubber pads, and screw on the nuts until the tightness is moderate.

(d) When installing the sewer elbow of the return tank, first remove the nuts of the sewer outlet of the return tank and the water inlet of the toilet, put them back to back on the sewer elbow, and put the rubber pads on the sewer pipes respectively. Insert the upper end of the water elbow into the water outlet of the rear water tank and the lower end into the water inlet of the toilet, then push the rubber pad to the water outlet, screw on the nut, straighten the water elbow, and screw it with pliers until it is moderately elastic. When connecting the water supply and the splayed gate, measure the distance between the water tank drift gate and the water supply nozzle, match the nipple, install the splayed gate and put it into the water supply nozzle.

(e) Cut off the copper pipe or plastic pipe, then put the drift door and splayed door nuts back to back on the copper pipe or plastic pipe, wrap the asbestos rope or lead oil twine on both ends of the pipe, insert them into the entrances and exits of the drift door and splayed door respectively, and tighten the nuts.