Have you found a modeling method for long balloons?

1. First stretch the balloon, fill it with air, and then let it go, so that the balloon can stretch slightly.

2. Then tie the two ends of the balloon into a circle.

3. Fold the middle of the balloon slightly, and rotate the other end in the middle to tie a knot.

4. After dividing into three equal parts, rotate and tie the knot.

5. Next, arrange the whole set of rings, grab the middle with one hand, squeeze out three petals from top to bottom, and twist them twice to do a little finishing.

6. Then, make a small circle of the flower stalk and put it in the petals, and the combination will get stuck (the knot of the flower heart should also be twisted around the receptacle).

7. Then make a right ellipse and a single circle, and then twist a bear ear knot at the single circle to firmly fix the turning point.

8. The rest of the pedicel, in the appropriate position, is folded upwards, and after taking out the leaf length, it is rotated twice.

9. Do this action twice, and you can produce leaves.

10. Then, just tidy it up a little.