China Naming Network - Weather knowledge - Knitting method of key lanyard

Knitting method of key lanyard

The key lanyard is woven as follows:

First, put the key to be knitted on the braided rope.

Then fold one end of the rope back from the right.

Then press it on the rope that is pressed at the bottom.

Then weave in the direction of the key and pass under it.

Then go back and go through the round hole above.

Finally, tighten the rope and weave a key chain knot.

Rope weaving skills:

The double thread passes through the beads.

1. Prepare two wires, and then light one end of the blue wire with a lighter for a few seconds. When the thread ends melt, stick this thread on the outside of the orange thread, and quickly press the melted place with your fingers to make the two lines merge.

2. Pass the orange thread through the beads first, and then pass the beads smoothly with the blue thread.

Multithreaded thread

1. Pass the line 1 through 1 beads, and then pass the second line through the beads.

2. Clip the third line between the two lines that passed before, and then drag it slightly, and the third line will be dragged into the hole of the bead.

3. Pass the remaining threads through the beads in the same way, and put all the threads together to make 1 single knot.

4. Keep the required length at the end of the line, and then cut off the extra line.

Winding.

(1) short chain.

1. Take 1 lines as the center line, take 1 thin lines and fold them in half, put them above the center line, and wind the thin line A around the center line in one direction as shown in the figure.

2. Pass the thin thread A through the small circle left by the folded end as shown in the figure, gently pull the thin thread B, drag the thin thread A into the circle and fix it, then cut off the redundant thread ends at both ends of the thin thread, and press it after melting the thread ends slightly with a lighter.

(2) long stocks.

1. Prepare 1 line, cut 1 piece of double-sided adhesive with appropriate length, and wrap the double-sided adhesive outside this line.

2. In addition, take 1 strand and stick it on the outside of double-sided adhesive tape. Take the strand as the center line and wind it in one direction to the required length.