China Naming Network - Weather knowledge - How to disassemble d5 heating tank of jumper?

How to disassemble d5 heating tank of jumper?

Remove the heater water tank of this brand as follows:

1. Preparation: Turn off the engine and unplug the ignition key. For safety reasons, please make sure that the vehicle has stopped running.

2. Drainage: Open the drain valve of the warm air water tank to drain the internal coolant. To prevent the coolant from overflowing and polluting the ground, a container can be placed under the drain valve.

3. Dismantle the water pump and thermostat: In order to disassemble the heater box, it is necessary to disassemble the water pump and thermostat from the heater box first. Use a wrench or socket wrench to remove the connecting bolt.

4. Dismantle the heater box: Find the connection between the heater box and the engine block, and then carefully remove the heater box from the engine block.

5. Cleaning: After disassembly, clean up the residual coolant and dirt.

6. Install the new heater water tank: Install the new heater water tank in the reverse order of removal. Ensure that the connecting bolts are tight and there is no leakage at the joint.

7. Add coolant: Fill the heater water tank with a suitable type of coolant. Note: When adding coolant, keep the engine cool.

8. Start the engine: start the engine and check whether the coolant circulation is normal. If leakage is found, please stop the engine immediately and check the cause.