How to take out the changan cs35 heater?
How to take out the changan cs35 heater?
Pull out the air pipe under the water supply pipe on the left side of the heater. Remove the water supply pipe bracket on the left side of the firewall. Loosen the mounting bracket nut under the water supply pipe bracket. Loosen the right mounting bracket nut under the oil return pipe. Remove the two mounting nuts at the top of the heater. Disconnect the control line of the blower motor switch. Disconnect the control line on the heater side main valve. Separate the heater from the mounting stud, then lift the heater and remove it from the vehicle.
Changan cs35 turns on the hot air first. After the car starts, the water temperature rises to normal temperature in about 8- 15 minutes, and the warm air can be turned on at this time. Adjust the circulation mode of the air conditioner to in-vehicle circulation, and finally use temperature adjustment to raise the temperature.
Turn to warm air mode, some cars are in the red area, and some cars use the sun to say, don't turn on the air conditioner switch (don't turn on the AC switch), because warm air uses the car's own thermal cycle to save energy! Empty adjust the gear of the blower to the appropriate gear, and adjust the wind direction of the air outlet (the direction of warm air blowing is generally forward blowing and foot blowing). Do you need to turn on the air conditioner in winter? Because the warm air in the car is not provided by the compressor, but by the coolant and the warm air box. Turning on the air conditioner is also forced refrigeration, which invisibly increases unnecessary wear and fuel consumption.
How to install changan cs35 heater box?
1. Place and fix the warm water tank. 2. Install the heater water supply pipe behind the cylinder head. 3. Place the vacuum tube and lamp wire behind the heater control device. 4. Tighten the screws of the column. 5. Install the control panel. 6. Fill the cooling system with coolant.
Automobile water tank, also known as radiator, is the main component of automobile cooling system. The function is to dissipate heat. The cooling water absorbs the heat in the water jacket. After flowing to the radiator, it dissipates heat, and then returns to the water jacket to adjust the temperature. It is an integral part of an automobile engine.
The automobile heating system heats the airflow inside or outside the car, and blows the heated airflow into the car again through the pipeline, thus forming warm air. Common automobile heating systems can be divided into three types: coolant heating, gas heating and exhaust gas heating. Coolant heating is used in automobiles. It consists of coolant, water pump, water valve, blower, warm water tank (heater core) and other components. The coolant is heated by the engine. After being pressurized by the water pump, the hot water enters the warm water tank from the water inlet of the warm water pipe through the rotary water valve which controls the coolant flow. The coolant entering the warm water tank enters the engine from the outlet of the warm water pipe and circulates.
When the heater box (heater core) is heated by the coolant, the blower is also working. The blower sucks in the cold air inside or outside the car and then blows it to the heater box. Cold air is heated by the warm air box and blown into the car, thus increasing the temperature inside the car. How to take out the heater in changan cs35 and how to install the heater water tank in changan cs35 @20 19.