Buick Hideo water tank leaks. Do you want to change it?
The Buick Hideo water tank is leaking. It should be a small water tank or a water tank, that is, the sealing ring of the warm water tank is broken, just in front of the accelerator pedal. Replacing the sealing ring again can solve the problem, or replace the heating box. It is recommended not to replace the original factory or install reinforcement. Check whether the water tank cover is fastened. Unscrew the oil cover to see if there are any traces of oil emulsification (punch or pin corrosion). If there is something wrong with the engine cylinder gasket, it is necessary to disassemble the engine and replace the cylinder gasket. It is also possible that the quality of the water tank itself is problematic.
If the water pipe of the water tank leaks due to vehicle vibration or vehicle accident during driving, measures can be taken according to the specific situation: 5~ 10 minutes after the cooling water is turned on to start a large cycle, the water tanks, rubber pipes and rubber pads in all parts of the cooling system will stop leaking (or prevent freezing), and there is no need to release them after stopping leaking, which will not affect the heat dissipation and blockage.
Dismantling steps of Buick Hideo water tank When disassembling Buick Hideo water tank, the first step should be to disconnect the negative battery, remove the front bumper and bumper center bracket and related wiring connections, as well as the original air inlet pipe of the air filter and the air seal of the water tank. Step 2: If there is a booster system, disassemble the booster air cooler, drain the cooling system, disconnect the water tank, gearbox cooler and other related pipelines and water tank fixing screws, and then take out the water tank.
(Photo/Text/Photo: Ask and Answer the Beast) Model Y Model 3 Model X V Li ONE Xpeng Motors P7 @20 19