China Naming Network - Ziwei Dou Shu - How to drain the water tank of Sany mixer

How to drain the water tank of Sany mixer

The operation steps of adding water are as follows:

1. Self-mixing concrete mixer should control the air pressure in the water storage tank, and often tighten the pipe joint.

How much air pressure should be injected into the tank? This has been set at the factory, so you don't need to adjust it yourself. If it is necessary to adjust under special circumstances, it is suggested that the pressure should be controlled at about 3.5Mpa, which is easy to burst if the pressure is too high. In addition, in new cars and daily use, the pipe joints should be fastened at any time to prevent them from falling off.

2. Step of adding water to the tank car

The layout of the water adding location of each tank car is similar, and the water tank is generally emptied-water is added-water adding valve is closed; When not in use, put the position of the pull rod in the middle. Here, we take 12 cubic meter tank car installed on heavy truck chassis and Xugong as an example to demonstrate.

3. Drain the remaining water in the water storage tank in winter.

In winter, especially in the north, users should drain all the water in the water tank and water pipe after collecting the car every day, and inject compressed air into the water pipe to blow out the residual water in each pipe to prevent the pipeline from freezing and cracking.