Method for make 38-day handmade flowers
Material preparation: 2 pieces of 15x 15cm handmade origami and 2 pieces of adhesive tape.
Operating steps:
1. This flower needs a piece of paper as its stem, so you can choose gray or green. Choose a piece of paper to make flowers. Fold the patterned or colored side outward into a triangle, then fold the left corner and the right corner into a small triangle, and finally open the small triangle.
2. Fold the petals. Fold the corner of the left triangle along the middle crease, and this corner will be folded out of the original triangle range, which is about the same as the vertex angle. The right corner is also folded like this, and it is as symmetrical as possible. Then put the flowers aside. Put the paper used to fold the flower stems, with the pattern or color facing outward. Fold it in half and put it in a square diamond shape.
3. Fold the right corner to the middle crease. Align the right edge of the paper with the middle crease, and make sure the bottom of the corner is also aligned. The left side is also folded like this, and it will be like a kite after folding. Fold the left and right sides to the middle crease. Make sure the bottom edge is aligned and sharp, and the crease in the middle should be compact.
4. Fold the upper right corner down to the middle crease, as well as the left side. The thin seam between the two halves should also be tight. Fold the top of the kite down to two-thirds of the bottom of the kite. Fold it around again. This plump little triangle is a leaf.
5. Roll up the stem and roll out the sharp one. Then gently pull the leaves out of the stem. Combination flower. Cut a small piece of paper at the bottom of the flower and make a few small holes in the stem. Tape the flowers to the stem to prevent them from separating.