Installation method of trackless prin floor

Trackless printed floor is a new type of environmental protection material and a hot trend of modern home decoration. Compared with the traditional floor, it is lighter and easier to install, non-toxic and tasteless, and the surface is smoother and more wear-resistant, which meets people's requirements for home environmental protection. Next, Bian Xiao will share the installation method of trackless printed floor for you.

First, check the ground state.

First of all, make sure that the ground of the site is clean and flat, and there is no unevenness. The ground must be flat, otherwise it will have a certain impact on the floor installation.

Second, measure the room size.

Accurately measure the length and width of the room and calculate the building area to be purchased.

Third, prepare the installation materials

The installation of trackless printed floor requires the use of matching floor tiles, floor glue and paving tools, such as plumb lines, trimming knives, rubber hammers, floor cutters, etc.

Fourth, start the installation.

1. Mark the center line of the ground with a plumb line first, and horizontally pull out equidistant longitudinal slab joints on both sides of the center line.

2. Spread the floor glue evenly on the ground. Before the coated floor glue is dry, lay the first floor flat on the ground and straighten it along the vertical line.

3. Continue to lay the next layer in turn according to this principle.

4. After basic paving, use a floor cutter to cut the floor at the side.

5. After paving, pat gently with a rubber hammer to make the floor fully fit with the ground.

6. Finally, cleaning, that is, cleaning and removing impurities on the floor surface by wiping the floor.

The above is the installation method of trackless printed floor. You can follow these steps. In the installation process, we must pay attention to safety, patient and meticulous operation to ensure the beautiful, stable and durable floor.