Disconnection binding method

The broken thread connection and binding method is:

1. The first method is to fold the sub-thread in half to determine the appropriate hook distance, and then tie a knot at the top. This knot is an ordinary figure-eight buckle, the same as the buckle used to connect the pole at the top of the main line (it will form a thread end after tying, the smaller the better, otherwise it will get entangled during use), tie the sub-line well.

2. The second method is suitable for unknotted sub-threads. The steps are similar. First, fold the sub-threads in half to determine the hook distance, then directly pass through the figure-eight ring and then cross the sub-threads in twos. , the first two steps to make the simplest buckle are the same as the first operation method.

What are the disconnection wiring methods?

The first connection method is butt connection, peel off the two wires and then cross-wrap them on the two wires.

The second type of T-shaped wiring is to wrap one wire around another wire to form a 90-degree angle.

The third connection method, plug-in, involves two multi-strand wires being broken apart to a certain length for plug-in and then tied tightly with a binding wire

Single-strand copper core wire Straight-line connection and T-shaped connection;

Butt joint of two-strand wires;

Straight-line connection and T-shaped connection of multi-stranded copper core conductors;

Varies Butt connection of diameter copper wires;

T-shaped branch connection of single-strand wire and multi-strand wire;

Connection of soft wire and single-strand hard wire;

Aluminum core wires are crimped with crimping tubes;

Aluminum core wires are crimped with crimping tubes.

Wiring method for broken nylon thread:

1. Make the end of the nylon rope into a loop and put it on the index finger of your left hand. Press the end of the rope with your left thumb.

2. Loop the nylon rope around the index finger of your left hand with your right hand, then press the end and knot of the nylon rope.

3. Loop your right hand around the ring with your left thumb. Pull the nylon rope to the left.

4. Use both hands to tighten the connection point.

5. Repeat steps 1 to 4 until the required length is achieved.