1 1 How to remove the plastic cover of the front bumper of Audi A6 water jet motor?

Look at the structure first, figure out the structure, and pay attention! Disconnect the battery ground wire before overhauling the electrical system.

Note: Before disconnecting the battery, you should check the security code of the recorder. If the battery is turned on again, start the vehicle equipment (recorder, clock, electric door and window lifter, engine) according to the operating instructions.

Remove the windshield wiper system and ensure that the wiper motor is in the edge position before removing the wiper arm. Remove the electric appliance box cover before removing the wiper motor. Remove the wiper arm and take off the wiper blade. If you open the top cover, you will see that the screws at the back are hexagonal. Using a screwdriver and an Allen key, pry open the two covers on the wiper arm.

But don't unscrew it completely, turn it slightly to loosen the wiper arm, unscrew the hexagon nut completely to take the rain wiper arm, and pull off the three clips on the front cover. Pry open the front cover at the edge of the windshield. If there are no screws, pull them by hand. Try it gently. If there is no screw, don't pull hard. You can guide the implementation through people who know cars, or consult professionals. Of course, if you feel too much trouble, you can go directly to the garage, Audi 4S shop, shopping places and other ways to solve it. People who buy a car will know more about the structure, parts and accessories of the car in their own cars.