Where is the temperature sensor of hatchback fit in 2005?

Honda Fit thermostat was located on the left side of the engine cylinder head in 2005, along the water inlet pipe. The thermostat is installed on the vehicle to protect the engine from cylinder explosion due to excessive temperature during operation. If there is no thermostat in the vehicle, it will affect the driving of the vehicle, and in serious cases, it will lead to engine scrapping.

The position of Honda Fit sensor is as follows:

1, oxygen sensor: The oxygen sensor is installed on the exhaust pipe to monitor the burnt gas to judge whether the engine is fully burned and whether the mixing degree is too thin or too rich;

2. Wheel speed sensor: Generally, the wheel speed sensor is located on the front wheel brake disc, which mainly collects the speed of the car to judge whether there are signs of slipping. Therefore, there are special sensors to collect the wheel speed of the car to complete this work, which are generally installed on the hub of each wheel. Once the sensor is damaged, ABS will fail.

3. Water temperature sensor: The water temperature sensor is installed beside the thermostat to convert the temperature of the cooling water into an electrical signal, increase the fuel injection amount or increase the ignition advance angle at low temperature, prevent explosion at high temperature and delay the ignition advance angle;

4. Intake pressure sensor: generally installed next to the throttle. As the name implies, the intake pressure sensor senses a series of resistance and pressure changes with different engine speed loads, and converts them into voltage signals for ECU to correct fuel injection quantity and ignition timing angle. If it fails, it will cause problems such as difficult ignition, unstable idle speed and weak acceleration.

(Photo/Text/Photo: Pacific Auto Network Q&A called Beast)