China Naming Network - Ziwei knowledge - Location of towing hook before sagitar of model 09

Location of towing hook before sagitar of model 09

The old sagitar front trailer is hooked in the right protective cover of the front bumper.

The traction ring must be carried with the vehicle. Pay attention to the traction instructions. The specific operation steps are as follows: install the front traction ring, take it out from the vehicle-mounted tool in the trunk, press the upper area of the cover plate, and loosen the buckle of the cover plate. Take off the cover and let it hang on the car. Screw the traction ring counterclockwise into the bracket. Screw the traction ring into the bracket firmly and reliably with a suitable tool. After the traction is completed, unscrew the traction ring clockwise.

Insert the upper locating tab of the cover plate into the opening on the bumper, and then carefully insert the lower locating tab into the lower locating slot of the opening. Press the lower area of the cover plate until the locating tabs engage in the bumper. It should be noted that the traction ring must be firmly and reliably screwed into the threaded bracket, otherwise the traction ring may damage the threaded hole when the car is towed.

Matters needing attention in towing trailer

It should be noted that the towing tools used to tow the trailer are divided into two types: soft tow rope and hard tow bar. Towing rope is mostly made of high-strength fiber fabric or steel wire, and tow hooks and locks are tied at both ends of the towing rope. The hard trailer pole is made of steel pipe or iron pipe instead of rope, and both ends are equipped with traction hooks and locks.

Considering the use safety and trailer effect, trailer pole is undoubtedly a better choice. When towing, the rigid trailer rod has better traction transmission ability, especially when the towed vehicle loses braking control, the rigid trailer rod can ensure that the front vehicle will not be hit by the rear vehicle when braking too hard.