Fox throttle reset method
2. Turn off the key and wait for 20 seconds.
3. Turn the key to NO and press the accelerator to the end 15 seconds.
4. Turn off the key and wait for 20 seconds. Note: Turn off the key and don't pull it out.
5. For the original fittings of the same variety and model, turn off the switch, turn on the switch key for 30 seconds after replacement, and let the ECU "learn by itself". Shut down, repeat, and start again. Don't start it immediately. After starting, after a short warm-up at fast idle speed, it will resume normal idle speed without computer detection.
6. If the stable idle speed cannot be restored or the fuel consumption is high, the original position of the throttle valve of the new part deviates from the sliding resistance by 0 point (improper assembly in the factory), which is inconsistent with the original machine. A tester is needed. Unconditionally, the battery anode pile head can be disassembled for 3-5 minutes and then reassembled.