How to solve the problem of long running water in toilet

1, toilet water keeps causing long running water. Hold down the drainage and unscrew the central sewer to see if there is sediment at the bottom. If there is sediment, it will not close well, resulting in long running water in the toilet.

2. Clean it up and put it back. Look at the floats again. There is a small switch on the side. Pull the switch, the water level will rise, fall and adjust to the appropriate position. Then, there is a screw on the kitchen label. Turn the screw to adjust the water level.

About the inspection of the toilet:

If the chain connected by the floating ball upright pole of the toilet is too short, there will be continuous running water in the toilet. At this time, it is necessary to lengthen the length of the chain appropriately. And check whether the nut for fixing the water tank is tightened. Once it is found loose, tighten it in time to ensure its use.

Open the water tank of the toilet and check whether there are small sand grains in the floating position, which may easily cause blockage. If there is, it needs to be cleaned up in time. Then look at the sealing ring of the water valve body. If it falls off, you need to go back with the fashion. If it is damaged, a new sealing ring needs to be replaced.

If the water tank is damaged by a large external force, it will continue to flow to the toilet. At this time, it is necessary to use special glue for repair work. If the water tank is damaged, you can only contact professional maintenance personnel for door-to-door treatment, or directly replace the new water tank.