How to add antifreeze to landwind x5?

When the car cools down, open the engine compartment and check whether the coolant is sufficient. The side of the coolant pot has an upper limit scale and a lower limit scale. When the liquid level is lower than the lower limit when the vehicle is cold, the addition amount shall be subject to the scale on the pot side, as long as it is between the maximum (max) and the minimum (min).

Steps for replacing antifreeze (antifreeze coolant)

Step 1: Check

First, do a comprehensive inspection to see if there are cracks and leaks in the pipeline, with the focus on the five-way pipe (named after the five interfaces connecting all parts). Antifreeze must flow through the five-way pipe and then be distributed to different parts of the car in order to play a role.

Step 2: Clean

Drain the old antifreeze, clean the liquid channel with clear water, add clear water to the antifreeze replenishment tank, then inject clear water into the tank to make the clear water continuously flow through the engine cooling system, then start idling for 3 to 5 minutes to make the water circulate, and the water flowing out of the water tank is a little pink, and continue to inject clear water until the water flowing out is clean. Don't forget to remove the heater hose and clean the heater tank.

Step 3: Replace with new antifreeze.

In order to make antifreeze flow into the water tank quickly, after draining for about 1 hour, add new antifreeze from the water pipe of the water tank (radiator), and then add a bucket of antifreeze to the antifreeze tank until the antifreeze tank is almost full, and ignite the car for about 10 minutes. At this point, the liquid level of the cooling system drops due to the exclusion of some air, and then antifreeze is added as long as the liquid quantity is at the highest (MAX