Detailed explanation of manufacturing steps of ceramic tile kitchen cabinet

There are 12 steps in the production of ceramic tile cooktop cabinets, and the specific operation of each step is described in detail below.

Determine the size of the furnace

First of all, be sure to determine the size of the stove and try to ensure that all tiles can be laid, so that the later construction is more convenient.

Short lead

Measure a suitable short lead (or make a frame with wooden strips) with a thickness of about 4 ~ 5 cm.

Tied steel keel

Tie the reinforcing steel keel of the countertop bottom blank, make a circle around the periphery according to the size of the wooden frame, and vertically tie it into a # shape every 10CM in the circle.

Spread oil paper or newspaper.

Spread oiled paper or newspaper on a clean floor and put a wooden frame on the paper.

Mud water operation

Start mud operation, put a thin layer of cement yellow mortar on the wooden frame, and place the steel keel in the wooden frame.

deposit concrete

Pour the fine stone concrete into the wooden frame, then tamp it with tools, and the surface should be leveled. The amount of cement should not be too small, otherwise it is likely to cause the blank at the bottom of the table to be too thin and easy to be damaged.

Let's stand for half an hour

After standing for half an hour, you can clearly see that the concrete surface absorbs water, then beat the concrete surface with an iron trowel, and then rub the concrete surface with a wood trowel to make the surface smoother and rougher. At this time, start to cover and maintain with wet straw bags or broken sacks, and it is best not to move during this period.

Cure for three days

The curing time is three days, and the wooden frame can be dismantled when the time is up.

Plane tile

Before tiling, tile should be laid horizontally and vertically on the cement floor in the order of leveling first and then standing, and the thickness of adhesive is about 0.2~0.3CM.

Paving tile

When paving facade tiles, the thickness of adhesive should not exceed 0.2 ~ 0.3 cm to adapt to the size of the convex edge of planar tiles.

Lay two layers of tiles

After the vertical brick is fixed, lay a layer of ceramic tile on it. After laying a layer, you can lay another layer on it with cut broken tiles to increase the height of the countertop.