When decorating the doorstone, the stone was too big and split in two. What should I do now? What?

(1) Each lintel should not be laid in two equal parts, that is, the lintel has a middle seam centered on the room.

(2) If the stone width cannot be limited to a whole block, it is better to divide it into three pieces, that is, divide it into two halves first, and then divide the remaining half into two halves. When paving, two small pieces are on both sides and half large pieces are in the middle.

(3) If it can't be a whole piece, it must be divided into two halves, so it can't be paved in two halves separately, but it must be paved in two unequal parts with staggered joints.

(4) coins can be placed. If you put coins, you can exchange them at the bank.

Extended data:

Matters needing attention in lintel installation:

1. The height difference between the bathroom and the corridor should be considered when crossing the threshold. If the height difference is less than 2 cm, there is no need to add sticky edges on one or both sides. Consider the edge of the threshold. According to the actual situation, consider 3*3, 5*5 or 20*5, but the key point is to do a good job of protection, and it is six-sided protection.

3. The ideal time for lintel installation is when putty is scraped. Because the existing wall is not straight, it is difficult to install. Therefore, in order to better fit, the windowsill stone and lintel often move a few knives on the wall, which will make the part of the windowsill and lintel that looks in contact with the wall more unified and beautiful after installation.