Installation method of diamond shower room with stone base size
Stone foundation dimensions of diamond shower room
First observation: first observe the shape of the bathroom; Observe the position of faucet, toilet and sink; The location of the bathroom floor drain. Measure the size of the shower room: If the stone base of the shower room has been paved, it is much more convenient to carefully observe whether the straight edge of the stone base is parallel to the brick seam of the floor tile. What's the angle of the diamond type with a square first? Whether it is 135 degrees, then measure the size from the wall edge to the outer edge of the stone base, and finally measure the length of the three sides of the diamond; If the stone foundation is inclined, the measurement will be much more complicated. Take a 900 * 900 standard stone foundation and put it on the stone foundation, and measure the size difference with a tape measure to get the length dimensions of three sides of the diamond shower room. At the same time, measure the two angular dimensions of the diamond with a square ruler to see if it is 135 degrees.
It is also necessary to measure the angle of two stone foundations against the wall with an angle ruler to facilitate the design of unmarked angle codes or profiles, and the size must be in millimeters; And observe whether the height of the shower room can use the standard height and whether there are items such as water heaters that affect the height. It is recommended to use the standard height as much as possible. Sketch: Draw a sketch of the shower room according to the results of field measurement, indicating the width and height of the rhombic shower room, and at the same time indicating three dimensions, indicating the orientation of the shower room and the direction of opening the door, and indicating the position of sanitary ware that may interfere with the shower room, so as to facilitate designers' careful consideration.
Installation method of diamond shower room
1. Before installing the diamond shower room, you should prepare the corresponding tools. The size of the diamond shower room, the taps, nozzles, showers and pipes used should be prepared in advance, and the cement worker should install the water stop of the shower room when doing it. However, the installation of shower room is at the end of construction, and the time span is quite long, so many problems are easily overlooked.
2. The common standard length and width of diamond shower room is 900 * 900 mm, and a corner of this standard is just below the door cover line. So the problem is that all diamond shower rooms are the same, and the length and width are calculated to the outer edge of the water stop. The aluminum frame and glass in the shower room can't be installed because they are blocked by the door cover wire. In order to install the shower room smoothly, the installer can only cut the door cover line with a cutting machine and chisel off the excess with a chisel.
3. When installing the aluminum frame, the master must adjust it vertically, and at the same time leave a certain gap between the aluminum frame and the door cover line. After installation, seal it with glass glue or sealant to prevent the water from running out of the shower room in the future, which will cause the door cover to be damp.
This paper is mainly based on the size of the stone foundation of the diamond shower room to give you some relevant knowledge. The article has written all the corresponding sizes for you, so that we can refer to these sizes and see if our bathroom can reach this specified size. If you can, you can choose a diamond shower room and learn about the installation method of the diamond shower room.