How to install the actuator motor of Ou Man est warm air water valve

2. It can also be installed outdoors, but attention should be paid to avoiding direct sunlight and direct rain.

3. Before installing the electric actuator, the pipeline should be cleaned, and a filter can be installed at the entrance of the valve to facilitate the removal of impurities.

4. The vertical installation effect is good. If installed at other angles, ensure that the cable interface position is higher than the strike position to avoid water flowing into the actuator along the low potential.

5. The connection between the flange of the valve body and the pipeline should be natural coaxial to avoid shear stress, and the connecting bolts should be evenly locked.

6. Set aside a certain space during installation to facilitate other maintenance operations in the later period.

7. In case of emergency, bypass should be appropriately added when installing in important areas.

8. The valve body needs the same heat preservation treatment as the pipeline, especially when it is used in high temperature medium. Otherwise, the high ambient temperature will affect the normal operation of the electric actuator.

9, electric actuator shall not be submerged, wiring should comply with the specifications.

10, make sure that the voltage meets the standard before energizing, so as not to damage the motor.

1 1. During maintenance, the power supply must be turned off. The above is how to install the water valve actuator motor of Ou Man est water heater.