River Fishing Tips
If you want to fish in the river, you need to master relevant skills. So what are the fishing skills? Come take a look with me below.
1. Basic understanding
Because the water flows fast when fishing, it is necessary to minimize the interference of small white stripes and other small miscellaneous fish, so that the fishing group can quickly fall to the bottom and make the fishing group more comfortable. The fishing group has a spacious fishing condition, so it must use long rods, long lines, heavy drops, and big drifts.
2. Principles for preparing the fishing group
It is not much different from the ordinary fishing group for static water fishing. It is equipped with all the rods and lines, but uses a long rod of 6.3-7.2 meters. good. The main line is slightly thicker than that for still water fishing, and the preparation of the brain line is determined by the pulling force of the fish (it should not be too thick to prevent the bottom from hanging and play a role in protecting the car from losing the car). It is better to use No. 5 to No. 6 thick tail floats for floats and Iseni No. 2 to No. 3 hooks with wider gates for fishing hooks. The sensitivity of the fishing group is not high.
3. Fishing positions
The backflow areas on both sides of the upper source of each river are the best. Rivers and canals mainly serve agricultural production and flood and drought relief. They have certain water level standards. If they exceed the standards, they will be discharged. In places with sufficient rainfall, water in rivers and canals continues to flow all year round. Due to the abundant oxygen in the upper source, the flowing water brings a variety of rich bait, and the habits of fish, after swimming to this waterway, they are neither able to continue upstream nor willing to go down, forming a relatively large gathering area. Because the river is deep and the current is fast, electric fishing and net fishing are ineffective and have little interference with the fish. The general fishing position is 50 meters away from the rapids area of the "eight" shaped gate. Since the "eight" shaped gate has a narrow water surface, and both sides of the river water surface are much wider than the gate, a backflow area on both sides and a corresponding slow-flowing water area within 200 meters are formed (the corresponding fish density is much less at a distance of more than 200 meters).
4. Adjusting the float
On the basis of adjusting the float in flat water, remove 2 to 3 mesh of lead skin, increase the support force of the float, and throw the main line into the water surface where you are fishing. After repeatedly testing the depth of the water level several times, when the water flow rate is not very fast, it is best to adjust the float on the main line until the hook group falls to the bottom. It is best for the float to lie in a reclining position for 2 to 3 seconds before starting to stand upright and sink. If the water flow is fast, it is best to raise the float until the float lies flat on the water after the fishing gear falls to the bottom, and then starts to stand upright in 3 to 5 seconds.
5. Making nests
After several years of exploration in running water fishing, the effect of making bottom nests is relatively obvious. It is best to use granular bait, such as ground corn. No matter what kind of base is used, be sure to add some white flour appropriately, mix well and pinch tightly to increase the atomization effect and extend the storage time of the base. According to the flow speed of the water, the nest is tilted upstream so that the bait falls to the bottom right in front of the fishing position (because if there is good fish news in every fishing spot, there are many people who are determined to fish, and only the front is your real fishing spot. fishing position). Due to the erosion of running water, throwing a fist-sized bottom bait every hour can maintain a good hook rate for a long time.
6. Fishing method
Hang a medium-sized whole red earthworm on double hooks, and throw the fishing group to the water above where the rod line can reach. Due to the action of flowing water, the main line and fishing group are also drifting downstream during the sinking process. The float starts from lying flat or reclining vertically and then sinks. Before the float completely sinks into the water, the fishing group moves on the uneven river bottom, causing the float to rise and fall with great movement. This is not a sign that the fish has eaten the hook. The key at this time is to use the pole tip to gently hold the main line, neither tight nor too loose. If the float sinks, gently lift the pole tip to pull the float out of the water, which can reduce the chance of hanging on the bottom. If a fish eats the hook, a slight trembling sensation will be transmitted to the hand. At this time, if you raise the Yu quickly, you will surely hit the fish. If the float is moving in the current, no matter whether it is lying recumbently or upright, as long as the tip of the float flickers slightly and suddenly drops 1 to 2 meshes, the fish must be eating the hook, and the rod must be raised quickly to catch the fish.
When the flowing water brings the main line to the downstream and becomes straight, the rod must be lifted and thrown upstream again, forming a fishing area mainly composed of dens, with the upper and lower reaches close to 20 meters.