How to weave simple flowers in the middle of weaving slippers?
1, weave the blue thread back and forth. In typesetting, change yellow thread to weave 5 stitches, and reverse pick 1 stitch. Three more stitches. Reverse pick 1 needle.
2. Repeat knitting for 3 stitches, and pick 1 stitch to the last1stitch. Finally, all the 10 stitches were knitted. The reverse side is knitted first 10 stitch.
3, winding the blue line. Pick up the winding and go down there. Continue to knit 3 stitches and take 1 stitch in reverse.
4, the second round of the front, first knit 7 stitches, reverse pick 1 stitch. Continue to knit 3 stitches and take 1 stitch. After knitting, there are 8 stitches left, all of which are finished.
5. First knit 8 stitches on the reverse side, and then take the yellow thread around. Repeat knitting 3 stitches, winding and picking.
6. Change the yellow thread back and forth for the third time and repeat the knitting method of the first time. Change the blue thread and needle back and forth. The first row of I-flower renderings.
7. The front renderings of the fifth round, and the patterns behind them are all repetitions of the previous four rounds. Children knit 3-4 rows, women knit 4-5 rows and men knit 5-6 rows.
The simple method of weaving the middle flower of slippers is as follows:
First, the face of weaving slippers:
1, first knit the first row from 6 stitches; When knitting the second row back, don't knit the first stitch, add a stitch before the last stitch, and then knit the last stitch; Go back to the third row and don't knit the first stitch. At this time, it is already 7 stitches.
2. Starting from the fourth row, use No.2 wool, slightly tighten No.2 1, pull it to the back, and use No.2 to cross No.2 1 to start knitting. Take off the first stitch directly and don't knit; The second stitch begins to knit the No.2 thread, and when it reaches the penultimate stitch, one stitch is added to knit the last stitch; Go back to the fifth row and don't knit the first stitch. At this time, there were 8 stitches.
3. At the beginning of the sixth line, first pull No.2 to the back, and press (cross) with 1 to start knitting the sixth line. The method is as above.
4, so repeatedly, weaving to about 54 stitches (you can use the sole to measure the needle edge, slightly tighten the amount, measure half of the sole-the midline is separated, only measure half of the edge.
5. After weaving the middle part, 1 thread begins to return to the shuttle. That is, when knitting no. 1, knit the last dozen stitches first, and then knit the remaining five stitches together (1). After knitting these five stitches, immediately change to No.2, and then come back to knit the remaining five stitches (2), and so on, until all the 40 stitches of the previous shuttle are knitted.
Second, the lining of woven slippers: the lining can be woven with old thread or pure wool. Generally, it is made of three strands of coarse wool, and the knitting method is the same as that of the surface, but the number of stitches is different. Start with 2 stitches and compare the width with the face at the right time. About 20 stitches are in front of the shuttle, leaving 3 stitches at a time, and the last 5 stitches are returned to the shuttle. These 5 stitches don't need to be woven repeatedly. If you don't like the thick lining, you can adjust it appropriately.
Third, put on your shoes:
1, face first. Face the front of your face to the bottom of the sole, find the middle position of the top of the sole, and aim the front of your face at the front of the sole (don't tilt). Fix the front part with two lines to avoid tilting when straightening other places, and then start from the back along the edge with strong lines.
2, and then to lining, the method is the same as above.
3. Then, use an old sweater to cut out a pair of shoe pads (you can also use thread-knitted insoles) and sew them on the soles.
4. Finally, turn the lining over and then the face over, and a pair of wool slippers will be completed successfully.