What should I do if the screw turns in place and doesn't come out? -How to tighten the screw when it slides?

Many things are fixed with screws. If we need to repair or replace them, we can remove the screws and corresponding parts to make things useful again. However, due to various reasons, the screw will inevitably slip, and it will not turn out if it turns in the same place. So what can be done to solve this situation?

First, what should I do if the screws are spinning in place and can't be screwed out?

This situation is because the screw slipped.

1. First buy a screw puller from the market, and then cut off both sides of the screw with a tool, so that the screw can be split in half and fall off.

2. After inhaling white vinegar with a straw or syringe, put it on the inner wall of the sliding screw. After the acid substance in the white vinegar reacts with the screw, try to turn the screw and take it out.

3. First select a thin piece of cloth, tear it into strips, wrap it in a sliding screw, then clamp the screw with pliers, twist it continuously in one direction, and then take it off.

Second, how to tighten the screw when it slips?

You can wrap a layer of non-woven fabric or paper around the screw to increase friction. Or take a elastic belt, stretch it at the top of the nut, then aim at the nut with a screwdriver, then loosen the elastic belt, and finally tighten it with ordinary screws. Please note that the slip of the screw will not only affect the tightening, but also cause great trouble when loosening. It is recommended to replace the screw with a new one.

Third, how to screw without a wrench

First, all you need is a big screw with a nut. Usually there will be some left when installing cabinets, which can come in handy at this time.

Next, put the screw on the nut to be unscrewed, and then tighten the nut on the screw to make it reach the size of the nut to be unscrewed.

After that, you can use the screws like adjustable wrench. Most importantly, it is not easy to slip when unscrewing the nut.