Introduction to homemade plumbing and air conditioning methods

The main function of air conditioning is to change the indoor temperature to make people feel more comfortable in a closed space. We all know that turning on the air conditioner consumes energy, and it also costs electricity. If the air conditioner is turned on all day, the electricity bill will be more than ten yuan a day, and more will be wasted over time. So are there any energy-saving methods that can replace air conditioning? Next, the editor will introduce to you how to make your own water heating and air conditioning, so that you can achieve the effect of air conditioning by yourself.

How to make homemade air conditioner - micro air conditioner

1. Preparation materials: semiconductor refrigeration block, heater shell, cross-flow fan, aluminum radiator in the audio amplifier power tube, water tank , power supply, etc.

2. Find 10 12V5A refrigeration blocks and connect them in parallel. Its power should be about 600W. Then use a PTC heater, disassemble its shell and take out the original PTC piece.

3. Then use six rectangular copper plates to weld into a water tank of a suitable size. Of course, this water tank cannot leak. Then use 4-6 pieces for the three components of the refrigeration block, radiator, and water tank. screws to hold them together.

4. Then drill holes according to the position of the heater shell and the fixing screws. At the same time, use screws to tighten and secure. Of course, the tighter the fixation, the better.

5. Drill two holes in the water tank, weld two pipe joints at the same time, then put on the plastic water pipe, use refrigerant circulation, and use a small water pump to drain, you can make this This miniature air conditioner reaches maximum power.

Homemade air conditioner - Homemade air conditioning fan

1. Preparation materials: a small table fan, one meter long plastic pipe, one meter long bare copper wire, small water pump , cable ties, small water tank.

2. During production, you need to bend the copper tube according to the lines on the fan, so that the copper tube can fit evenly onto your fan;

3. Bend the copper tube After that, use your nails to bend the tie into a "J" shape, and then fix the copper wire and the fan. After fixing, use scissors to cut off the excess tie;

4. After Use the prepared plastic water pipe, connect the two ends of the plastic water pipe to the two ends of the copper wire, and then use scissors to cut a small opening in the middle of the water tank to place the water pipe to prevent it from rolling;

5. Let the Connect a section of the water pipe to the small water pump, and then place the small water pump into the water tank. This is done.

How about it? The method introduced by the editor is very good, right? By making your own water heating and air conditioning method, you can enjoy warm and comfortable heating, and the cost is relatively low. If you don’t have an air conditioner, or If you want to save energy, you can try this method. To change the temperature by making your own water heating and air conditioning, you may need to choose the amount of materials according to the size of the area, otherwise the effect may not be good enough, but if you prepare too many materials, it will be a waste of resources.