How to control cylinder stroke

1, which can shorten the stroke of the cylinder. The current cylinder is SC63* 1300, and the current cylinder is changed to sc63 *1100 (1150, 1 120). If it is 1 100, add a screw with a length of 200mm; if it is 1 150, add a screw with a length of 150mm. In this way, the total length of the cylinder cover remains unchanged, and it will not open to 100 degrees because of the shortened cylinder stroke.

2. If you add a magnetic sensor, you must first confirm whether your existing cylinder has a magnetic ring, so that you can install it. In addition, after reading your equipment, I suggest you don't use magnetic switch to control it.

3. You can also change the opening angle of the cover by changing the point of the cylinder mounting seat. Move the two installation points of the cylinder outward (install two clamps), and install two clamps by using the existing bolt holes, so that the stroke is the same, and the opening angle of the cover can also be changed. This method is probably the safest and requires less money.