The hinge of the bathroom door at home is broken. Can such nails be pulled out and replaced by themselves?
Replacement of toilet door hinge-installation of toilet door hinge
When installing the bathroom door hinge, the distance between the hinge position and the door leaf should be about110 (generally 200mm) of the height of the door leaf. In order to ensure the accurate installation of the bathroom door hinge, when measuring the installation position of the hinge on the door frame and door leaf, both the upper hinge and the lower hinge are required to be measured downward from the upper part of the door frame or door leaf. The width of hinge is less than the thickness of toilet door, and the long side of hinge should be aligned with the back of door leaf. To avoid wrong hinge installation, it is best to draw a mark on the back of the door leaf.
For the connection between the hinge and the door leaf, measure 200mm, and draw a positioning line, align the short side of the hinge with the drawing line, and align the long side of the hinge with the back of the door leaf, then draw the outline of the hinge groove with the hinge as a template, and remove the hinge groove with a flat chisel. Hinge groove should be deep inside and shallow outside, and its depth should be based on the level of the hinge with the door leaf after installation. After removing the hinge slot, put the hinge in and fix it temporarily with 2 screws. Temporarily fix the hinge on the lower part of the door leaf in the same way.
For the connection between the hinge and the door frame, draw the positioning line of the hinge on the door frame:
Measure 200mm from the upper part of the door frame with a steel tape and draw a positioning line, align the hinge with the drawn positioning line and the edge of the door frame, and draw the outline of the hinge groove with the hinge as a template. The positioning line of the hinge at the lower part of the door frame still starts from the upper part of the door frame, and the height of the door leaf is reduced by 200 mm.
Finally, remove the hinge groove with a flat chisel. After removing the upper and lower hinge slots, put the door leaf into the door frame, and temporarily fix the upper and lower hinges on the door frame with two screws. Then check whether the gap of the bathroom door meets the requirements, whether the door frame is flush with the fan, whether the door leaf is open and closed normally, and where the door leaf is open. It is better to stop, and there can be no autism or autism. After passing the inspection, tighten the remaining screws.
Bathroom door hinge is the core component of bathroom door to realize its use function. It is a connecting or rotating device, so that bathroom door can rotate and bathroom door can be opened and closed. Generally, bathroom door hinges are made of stainless steel and copper. A good bathroom door hinge is in the form of a bearing. Generally, a door has four bearings to bear the weight of bathroom door.