How to choose and use Feng Shui compass
Geomantic compass is the main geomantic tool for geomantic masters to seek dragons and acupoints, expel sand and absorb water, and arrange vertically. The quality of tools is related to the accuracy of position measurement and directly affects the accuracy of vertical layout. Therefore, feng shui masters are very picky about compasses. To do geomantic omen well, we must know what kind of geomantic compass can be used in practice.
The compass consists of three parts: the seabed, the inner disk and the outer disk. The quality of the three parts is closely related to the measurement accuracy of the compass.
Compass bottom:
1. The circular box on the seabed should be a standard cylinder, and the positioning crosshairs on the seabed should be orthogonal, that is, at an angle of 90 degrees.
2. The casing shall be fixed at the intersection of submarine crosshairs and perpendicular to the seabed. The tip of the thimble should not be damaged. If the needle tip is damaged, the rotation of the magnetic needle will be slow and inflexible, thus affecting the accuracy of the pointer.
3, magnetic needle must be straight, can't bend or warp; Have enough magnetism; The weight of both ends of the magnetic needle should be the same.
4. The seabed cover is best made of glass. The cover made of plexiglass or plastic is easy to generate static electricity, which will attract the magnetic needle and affect the measurement accuracy.
5. When the glass cover is covered, turn the seabed upside down, and the magnetic needle should not fall off. When the seabed is put into the inner plate, special attention should be paid to the alignment between the north of the seabed line and the center of the inner plate sub-mountain.
Compass inner disk:
1. The contents of each layer on the inner disk are the main parts of the Feng Shui compass, and the disk surface is required to be flat, accurate and clear.
2. Meridians of the twenty-four mountains of the site should coincide with 360 degrees, 180 degrees, 90 degrees and 270 degrees on Sunday, and other plates should be set according to the standards of professional geomantic compass, and each plate should be in its place.
3. The inner and outer gardens of the inner plate must be standard. After the outer disk is put in, the gap between the inner disk and the outer disk should be kept within a suitable range and the width should be appropriate. The gap is too small, the rotation is not flexible, and the gap is too large, which affects the measurement accuracy.
4, the inner ring should be slightly tight, so that the seabed is not loose. The center of the inner disk should be concentric with the seabed.
Compass outer disk:
1, the outer disk must be a standard square with four sides not bent or skewed, and the center of the circular groove placed in the inner disk should be in the geometric center of the outer disk.
2. The entire disk surface of the compass should be smooth and flat without warping.
3. Tianxin 10 is the indicator line for reading the contents of each layer of the inner disk, and the four threading holes must be located at the center points of the four sides of the outer disk respectively.
4. For a compass with leveling bubbles, when the bubbles of both leveling bubbles are in the center, the magnetic needle on the seabed should be parallel to the disk surface. The quality of compasses sold in the market varies from place to place. When buying a compass, you can choose according to the requirements detailed above.