How to make a tube top
A, lining technology:
1, first make the inner layer of the upper part of the dress skirt. Better clothes, you can add chest pads. If fishbone is added under the chest pad, the model can be better supported and better results can be obtained.
2. Make an A-shaped skirt with a piece of interlining (the length of the skirt is longer than the total skirt), fold it with hard yarn below the waist (about 65438+ 0/3 of the width of the skirt, and the length is basically longer than 10CM of the sewing part), then start to put the first layer of hard yarn on the A-shaped skirt, and pleat the place where the hem of the last hard yarn is less than 5CM (that is, below the last hard yarn) Until the desired effect is achieved, these hard yarns are nailed up bit by bit by hand with bead needles, and then fixed by sewing a circle with hand sewing needles. Then continue to nail the second layer of hard yarn on the upper end of the first layer of hard yarn. In the same way, first nail it with a bead needle, and then sew it with a hand sewing needle. Nail the third layer of hard yarn. Some dresses and skirts can be nailed in two layers. In order to make it look fluffy and lovely, you can nail 3-5 layers of hard yarn, depending on the weight of the canopy and the outermost fabric. (This process is three-dimensional cutting) In fact, it is to sew a layer of hard yarn with a manual needle, then sew a second layer of hard yarn, then fix it with a manual needle, and then take the whole skirt off the model and sew it with a sewing machine (at this time, the car is fixed and reinforced on the basis of the manual needle, so when fixing the hard yarn on the skirt with a manual needle, be careful not to nail the cloth on the model together).
3. Make a big A-shaped skirt or flared skirt with external photo cloth (it can be wedding dress cloth or soft gauze of wedding dress) (the length of skirt is required, and some hard gauze is popular now).