Subline combination method

The sub-line binding method is as follows:

The secondary line is used to tie the hook in fishing gear, and the other end is tied to the eight-character ring to connect with the main line. When tying the hook, pay attention to the moderate length of the thread. When tying, be sure to tighten it hard, and then cut off the excess part with scissors to tie a hook.

Subline hook:

First, measure the length of the parting line with the parting ruler, and then pinch the two ends of the parting line with the hook handle. Note that the directions of the two thread ends are opposite, and the bottom of the hook should be the same length as the exposed thread end.

The sub-line pointing to the end of the hook handle is wound on the hook handle from bottom to top for about six turns. After winding, tighten it, then cut off the excess part with scissors and tie the hook.

Tie the hook to the other end of the fishing line in the same way, and it is a double hook.

The secondary line has an eight-character ring;

The method of tying the eight-character ring is relatively simple. Prepare the auxiliary line and the special eight-character ring, and then pass the auxiliary line through. After that, tie one end of the sub-wire, pull this end over and wind it several times, and then pass through the ring of the eight-character ring, so that the wire is tied.

Especially when double hooks are used, the middle end of the sub-thread tied with hooks at both ends passes through the small ring of the eight-character ring, and then the hook is pulled out of the winding ring and tightened. Hooks and eight-character rings are tied.

The function of the auxiliary line is to protect the main line, which is several times smaller than the main line, so that it will break first when stressed to avoid the main line being stressed.