Haolaiwu handmade beaded tissue box kitten tutorial video
1. Starting from the bottom, cut a section of No.6 nylon thread, which may be 4 meters long (beginners can shorten it), as shown in the figure below. Wear four beads in the middle of the line, that is, keep the length of the left and right lines about 2 meters.
2. Grab the thread with your left hand. Grasp the thread with your right hand and wrap it around the front (from right to left) from the back of your left hand. After winding, put it back on the last bead on the original right hand (the direction is from right to left), and then tighten it with both hands (hint: the contact point of the two threads should be pulled to the center of the inner hole of the bead, so that the bead will be firmly fixed).
3. Next, wear one on your left hand and two on your right hand. Right-handed thread winds from the back of left-handed thread to the front (from right to left). After winding, go back to the last bead on the original right hand and pass through the last of the two beads on the right hand, not the previous one, from right to left.
4. The bead on the left hand side should be below the intersection of two lines. The operation of threading beads by hand is the same as the next step, but the number of threading beads has changed.
5. The next process is the same as the third and fourth steps. First, put the beads on, then wind them in turn, and so on, and put on ten groups of such small flowers (so that the vertical edge at the bottom comes out).
6. After putting on the tenth group, it will bend at this time. No beads on the left hand, three beads on the right hand. The action is the same as the second and fifth steps. After the right hand paper bypasses the left hand, the right hand gets the last of the three beads. Put it on and tighten it.
7. After turning the corner, the practice is still the same as the fourth and fifth steps. Wear one on your left hand and two on your right. Next, through four groups by analogy. After you wear it (so that the bottom horizontal edge comes out), you must turn it. The rotation operation is the same as step 6, without beads in the left hand and three in the right hand.
8. Then, continue to penetrate the other vertical edge of the bottom, and the method is the same as the previous steps 4 to 7. After you wear it, you must turn it. The method of turning it is the same as the sixth step. After turning the corner, continue to make another horizontal edge. The method of horizontal edge is the same as step 7.
9. All four sides are finished. Get the connector ready. The left-hand line passes through the top bead on the vertical side, and the right-hand line passes through two beads. Then the threading method is the same as the fifth step. After wearing it, tighten your hands so that the first layer at the bottom will be fine.