China Naming Network - Company naming - How to use Citroen C6 cigarette lighter? Citroen C6 cigarette lighter fuse location

How to use Citroen C6 cigarette lighter? Citroen C6 cigarette lighter fuse location

The position of 202 1 Citroen C6 cigarette lighter is shown in the following figure. Press the cigarette lighter into the hole to start heating, and it will automatically pop up after completion.

Citroen C6 cigarette lighter fuse location

The fuse is hidden in the left cover of the center console and can be found after removing the cover. The fuse of the rear cigarette lighter is located in the fuse box on the side of the trunk, and the baffle needs to be removed before inspection. In which compartment the fuse is installed, the component name and corresponding number are marked, and an example is given below.

1. Turn off the vehicle and turn off all power supplies. If it is a mechanical key, it needs to be pulled out.

2. Find the corresponding position of the fuse box and carefully remove the protective cover with a plastic crowbar.

3. Loosen the cover and remove it. You can check the exact location of the fuse of the cigarette lighter assembly from the inside.

4. Then use a measuring pen to detect the preliminary situation of the corresponding fuse. If one impulse terminal is connected and the other end is not connected, it may be that the fuse is damaged.

5. Remove the burnt fuse with the clamping tool and replace it with a new fuse with a fixed fuse.

How to use a cigarette lighter

1. The cigarette lighter is under the central control panel of the car, and the icon is a cigarette shape (or voltage value). Press the icon button to heat automatically, and it will rebound when it reaches the target temperature. Bouncing will be a little noisy.

2. Take out the lighter. The inner port is used for heating cigarettes. Touch the cigarette butt for a few seconds.

3. The open flame produced by the lighter is dangerous, and the cigarette lighter solves the safety problem well.

Reminder: fuses control the lifeblood of electrical equipment, and neither current nor voltage level can be checked. It may blow the fuse and even cause a fire. Therefore, it is not recommended that the owner disassemble and replace it by himself.