Practice of handmade rabbit lamp
1. 1. Preparation materials and tools: cooked rice paper, 2 meters of iron wire, four wheels, two straws, two thick iron wires, a piece of cardboard, scissors, pliers, white glue and paper tape.
2. Bend two groups with iron wire, and five groups have ten rings of different sizes. (Note: ten ring symbolizes perfection and is a good wish of the ancients for the New Year. )
3. Wrap the joint of ten rings with paper tape and seal the iron ring. This way, the rabbit lamp is not easy to deform. The opening of the iron ring will not cut rice paper.
4. Cross two large ellipses and fix both ends with paper tape.
5. Two circular iron rings are vertically fixed at both ends of the newly-made rabbit body to support the rabbit lamp body into an oval sphere.
6. Note that the place where the circle and two ellipses collide should be fixed with paper tape to prevent deformation when pasting paper.
7. Take out the other two circular iron rings and fix them with paper tape at the junction of two large ellipses and vertical rings. Then, the front ends of the two circular iron rings as heads are bonded with paper tape. Then two small oval iron rings are fixed on the oblique sides of the two iron rings with paper tape as rabbit heads.
8. Cross the smallest two round iron rings, fix both ends with paper tape, and then fix them at the other end of the body to make the tail of the rabbit lamp.
9. Adjust the shape of the rabbit lamp slightly, cut the cooked rice paper and paste it with white glue. (Note: the rabbit's abdomen does not stick to paper).
10, prepare a board, four wheels (which can be replaced by cardboard cutting), two straws and two thick iron wires, and cut the cardboard into the size of the bottom of the rabbit lamp.
Stick two straws on the front and rear ends under the cardboard respectively, put the iron wire through the straws, and put wheels on the left and right sides to make a scooter-like base. You can also put small light beads or light-emitting diodes on it to make the rabbit light shine!
1 1. Put the rabbit lamp with cooked rice paper on the base and adjust the wheels properly.
12. Cut out the shapes of two eyes, two ears and one mouth with red paper, and coat the back with white glue.
13. Paste the cut part in the appropriate position.
14. Prepare six sets of cooked rice paper with the same length and different widths.
15. Cut the cooked rice paper strips into thin strips (note: do not cut the roots).
16. Stick the widest strips of cooked rice paper on both sides of the rabbit, and don't leave too much hair under it, just slightly beyond the bottom.
17. Stick a slightly narrower rice paper strip on the newly cooked rice paper strip to make the hair of the rabbit lamp appear on the second floor.
18. After the finally cooked rice paper strip is also glued (if the number of layers of wool is not enough, it can be added appropriately), the rabbit lamp and the base are combined into one. Tie the rope to the rabbit's chest, and the rabbit lamp can be dragged.