How to change Foton diesel truck antifreeze

There are three steps to replace the antifreeze:

1. Inspection

Before completely replacing the antifreeze, you must first do a comprehensive inspection and look at everything Whether there are traces of leakage or cracks in the pipe, the key point is to check the five-way pipe

The water pipe is named after the five joints that connect various parts. The antifreeze flows through the five-way pipe. After the tube, you are assigned to different parts of the car to function. If there is antifreeze leakage in this part, you should

replace the water pipe or refix the interface according to the situation.

2. Drain the water

Drain the old antifreeze, and then clean the liquid channel with clean water. Add clean water to the antifreeze replenishment tank, and then inject clean water into the tank so that the clean water continuously flows through the engine cooling system, and then idle the car for 3 to 5 minutes to allow the water to circulate. The water flowing out of the jug will be a little light pink at first. Continue to pour in clean water until the water flowing out is clean.

Be careful not to forget to remove the heater water pipe and drain the water from the heater water tank.

3. Replace with new fluid

After draining the water for about 1 hour, add new antifreeze from the water pipe of the water tank (radiator). This is to prevent the antifreeze

Method for rapid flow of frozen liquid into the water tank. Then add another bucket of antifreeze to the antifreeze tank until the antifreeze tank is almost full, and drive the car for about 10 minutes. At this time, the cooling system has eliminated some air and the liquid level has dropped

Lower, then add antifreeze until the highest mark "MAXT" on the reservoir is reached.