How to adjust the Jetta automatic electronic throttle?

The traditional cable throttle is a steel wire with one end connected to the accelerator pedal and the other end connected to the throttle, and its transmission ratio is 1: 1. That is to say, the opening angle of the throttle is the angle we step on with our feet, but in many cases, the throttle should not be opened at such a large angle, so the opening angle of the throttle at this time is not necessarily the most scientific. Although this method is direct, its control accuracy is poor. The electronic throttle controls the opening of the throttle through cables or wire harnesses. On the surface, the traditional throttle cable is replaced by cable, but in essence it is not only a simple change of connection mode, but an automatic control function for the power output of the whole vehicle.

When the driver steps on the accelerator when he needs to accelerate, the pedal position sensor will transmit the sensed signal to the ECU through the cable. After analysis and judgment, ECU will send instructions to the driving motor, and the driving motor will control the opening of the throttle valve to adjust the flow of combustible mixture. Under heavy load, the throttle opening is large, and a large amount of combustible mixture enters the cylinder. If the cable throttle is used, the throttle opening can only be controlled by stepping on the depth of the accelerator pedal. It is difficult to adjust the throttle opening to reach the theoretical air-fuel ratio, but the electronic throttle can analyze and compare all kinds of data collected by sensors through ECU, send out instructions to make the throttle actuator act and adjust the throttle to the optimal position, so as to reach the theoretical air-fuel ratio 14.7: 1 under different loads and working conditions, and make the fuel burn fully.

Electronic throttle control system is mainly composed of accelerator pedal, pedal displacement sensor, ECU (electronic control unit), data bus, servo motor and throttle actuator. The displacement sensor is installed in the accelerator pedal to monitor the position of the accelerator pedal at any time. When it is detected that the height position of the accelerator pedal changes, the information will be sent to the ECU instantly. The ECU will calculate and process these information and data information from other systems to calculate a control signal, which will be sent to the servo motor relay through the line. The servo motor drives the accelerator actuator, and the data bus is responsible for the communication between the system ECU and other ECU. Because the electronic throttle system adjusts the throttle through ECU, various functions can be set to improve driving safety and comfort, among which ASR (traction control system) and speed control system (cruise control) are the most common.

I can only give you some information about the above professional problems. Sorry, please solve the car problem as soon as possible. Safety first, there can be no hidden dangers on the road.