How to solve it with a circular knitted bracelet

The schematic diagram of knitted bracelet with disc is as follows:

1. Cut out a circular paper tray, and cut out eight equally divided holes on the circumference as shown in the figure, with an opening in the middle.

2. Tie the end of 7 strands of braided wire, pass through the center of the paper tray, and clamp the knot on the circular opening.

3. Next, you can clip the wire into the holes on the edge of the board in the order shown in the figure.

4. Then you can knit like an ordinary knitting disc.

5, braided bracelet effect.

Matters needing attention in doing manual work

1, prepare tools and materials. Before making by hand, you need to prepare the necessary tools and materials. For example, if you want to make a sweater, you need tools such as wool, needles and knitting needles. If you want to make candy, you need materials such as sugar, pigments and molds. When selecting tools and materials, we should consider the actual needs in the production process to avoid waste and unnecessary trouble.

2. Pay attention to safety. Pay attention to safety when making by hand. For example, wear gloves when using knives to prevent accidental injury to fingers, and be careful not to burn yourself when using hot glue guns; Gloves and masks should be worn when using chemicals to prevent inhalation of harmful gases. If it is difficult to make by hand, it is best to do it under the guidance of professionals to ensure safety.

3. Pay attention to details. Hand-made needs attention to detail. For example, when making sweaters, we should pay attention to the neatness of stitches and the handling of thread ends; When making candy, we should pay attention to the matching of colors and the regularity of shapes. The treatment of details can not only improve the aesthetic feeling of the work, but also improve the practicality and durability of the work.

4. Pay attention to time management. It takes some time to make by hand, so we should pay attention to time management. The time and steps of production should be planned before production, so as to adjust the progress in time during production. If time is tight, you can consider adopting a simple production method to save time.