End of bracelet knotting method

The method of tying the bracelet is as follows:

1, snake knot: you can tie a snake knot at the end of the bracelet. First, the right rope is wound around the left rope clockwise, and then the left rope is wound around the left rope counterclockwise from back to front, passing through the right rope loop. Then tighten the two ropes and repeat the previous steps.

2. Double connection: Double connection can be made at the end of the bracelet. First, wrap the rope on the right to the left and tie a knot. Then thread the left rope into the right rope loop, wrap the left rope around the right, and tie a single knot to tighten the ropes at both ends.

3. Bird's head knot: You can tie a bird's head knot at the end of the bracelet. First, wrap the right rope around the left rope twice, so that the other rope passes through this circle, then tighten it, and so on, and repeat the previous knotting steps until you need the length.

4. Diamond knot: Take two different colored threads to connect the two ends, first wrap one of them around, then wrap the other one around and go in from the previous one, and finally shrink and cross the two circles to form a circle, and repeat the above steps to a suitable length.

5. Cocktail knot: Fold one of the lines in half, then wrap one line twice from the bottom of the other side, then pass through this line and penetrate into the front coil, and finally adjust it to the appropriate length directly in this way.

Other knotting methods of bracelets

1, semi-knot play: the rope is wound in a circle and then passes under it.

2, figure-of-eight knot play: through the rope, and then around the top, through the circle.

3, flat knot play: prepare two ropes, one rope on top, one around the city circle and then through the bottom.

4, three sets of knot play: use the rope to wrap around twice and then synthesize one.

5, fisherman knot play: 1 rope around a circle, from the lower circle around the back, and then through the middle circle.

6. Prussian knot: First wind the rope around the wood 1 turn, then wind the rope head over it, and then let the rope head out from the inside of the rope 1 turn.