Name, beaded name, then why not tie a knot?

1. It is very important to leave enough margin. The fishing line is thin and slippery, and it is difficult to tie the knot without tools if the remaining line is short. So don't be afraid to waste the thread at the beginning, and do a good job in the closing stage in advance!

2. Usually, when we tie a beaded ring with fishing line, we will choose to tie two knots, one straight and one reverse, so as to ensure that the knot we tie will not loosen after tightening. If you think two knots are not enough, you can tie another knot on this basis (in short, the combination of positive and negative can ensure the firmness of the knot)

3. Don't cut the root of the knot when making a short line, because the friction coefficient of the fishing line is very small, and if the residual line left after the short line is too short, it will also cause the knot to loosen. My practice is to leave about three millimeters of residual thread broken, and then burn the thread end slightly with a lighter to make it smooth and not scratched.

I hope the above three suggestions will help the baby who just arrived in into the pit.