How to disassemble the water tank of Chery Tiggo 8 heater?

Disassembly process of Chery Tiggo 8 heater water tank: first stop the car and turn off the engine. When the coolant temperature drops, open the expansion pot and inject cleaning agent into the water tank. Secondly, start the engine until the cooling fan works, and then idle for 5 to 10 minutes.

Then turn off the engine and remove the front bumper of the vehicle. When disassembling, make sure that all fixing screws have been unscrewed, and then slowly disassemble from both ends to the middle. Do not break the fixing buckle. Finally, ensure that the coolant temperature is completely cooled, then discharge the tank cleaner together with the coolant, and finally replace it with a new engine coolant.

Dismantling skills of automobile warm water tank

1. Drain the coolant from the cooling system.

2. Remove the control panel.

3. Separate the cable bracket on the left side of the heater and remove the screw on the terminal.

4. Unplug the wire connector behind the blower motor.

5. Disconnect the vacuum tube and lighting line behind the heater control device.

6. Place a container under the engine and under the heater water supply pipe behind the cylinder head.

7. Remove the heater water supply pipe behind the cylinder head.

Precautions:

1. In addition to a radiator in the engine compartment, there is also a heat exchanger in the dashboard of the cab, and the antifreeze used to dissipate heat in the engine flows in the middle.

2. Improve heat dissipation: Turning on warm air can improve heat dissipation in the car, which is especially useful for some Jetta cars to run long distances.