Where should I put the floor heating water separator? -How to install the floor heating water separator-
Where is the floor heating water separator? 1. In fact, the water separator can be installed in a large position, as long as the design is reasonable. For example, we can install it in the bathroom, which generally has a waterproof layer. If the water separator has the problem of running water, the water can slip away along the floor drain of the bathroom without causing other losses.
2. In addition, the water separator can also be installed outdoors. One purpose of outdoor installation is to facilitate later maintenance and repair. Generally, the kitchen balcony can be selected for outdoor location, and it can be discharged through the floor drain when dripping occurs.
3. In addition, the floor heating water separator can also be installed on the wall below the wall-hung boiler, which is convenient for installation and operation and sewage discharge.
4. The floor heating water separator can also be installed on the wall or in a special box, but when installing the water separator, it should be more than 30cm away from the ground and placed horizontally. Remember to install the filter in the kitchen during the installation, because this can ensure the normal use of the floor heating pipe.
1 How to install the floor heating water separator? Before installing the water separator, the insulation board should be laid first. The laying method of insulation board is also very simple. Just make the whole insulation board square, then put the cutting board in the middle, and then connect the two boards together with tape. However, it should be noted that the clearance should be as small as possible and not more than 5 mm
2. After the substrate is connected, a reflective film should be laid. Spread the corresponding reflective films into squares and squares, and then connect them with adhesive tape according to the previous step.
3. After the reflective film is paved, install the water separator tube. During installation, it shall not be forcibly installed. It should be based on the corresponding pipeline circulation and keep the corresponding pipeline distance during accounting. It should be noted that the pipes cannot cross.
4. The last step is to install the oil-water separator. First, connect both ends of the water separator to the pressure gauge and the automatic exhaust valve respectively, and then fix them. Then, install the corresponding filter at the water inlet of the corresponding water separator pipeline, and then cover it with the corresponding reflective film to protect the water separator, prevent impurity pollution and ensure its normal use.
This paper introduces the installation method and location of floor heating water separator, and its installation location is very important, so don't ignore it!