How to adjust the valve gasket of mg3?

The adjustment method of MG mg3 valve gasket is: the valve clearance is about 20 to 25, and the clearance is manually tested after adjustment. Adjust like any other car. Adjust the top dead center of one cylinder to one cylinder, two cylinders to three rows, and four cylinders to two rows to three rows.

Throttle is one of the most important components in EFI automobile engine system. The upper part is the air cleaner grille, and the lower part is the engine block, which is the throat of the automobile engine. Whether the acceleration of a car is flexible or not has a lot to do with the dirt of the throttle. Cleaning the throttle can reduce fuel consumption and make the engine flexible and energetic. Whether the throttle should be removed for cleaning is also the focus of discussion among car owners.

Throttle initial method

The first is to turn on the key in the second gear, that is, the gear indicated by the instrument is fully lit, then wait for 20 seconds, step on the accelerator to the end and hold it for about 10 second, then release the accelerator, turn off the ignition switch, pull out the key and initialize. According to different cars, the recovery methods are different, and some cars have to be initialized by computer.

The second is to turn on the key and keep it in the second gear for 30 seconds, then turn off the ignition switch and pull out the key. It should be noted that after the two methods are completed, it will take some time to try to ignite. Generally, you can wait 15-20 seconds, and then ignite to see if the refueling is normal and the engine fault light is off. If at first you don't succeed, do it again until you succeed.