How to connect the floor heating water separator with the floor heating pipe?

2. If you want to connect from the radiator, please use serial connection. Parallel connections cannot be used.

3, the temperature may be very high, about 30 degrees, so the pipe need not be too dense, about 25CM.

4. The use of pipes is also very important, because the heat source temperature of radiators is very high, and ordinary floor heating pipes are not good. PB pipes are recommended.

The main function of floor heating circulating pump is to increase the circulating flow of floor heating hot water. Therefore, in order to play its role, the circulating pump should be installed on the main pipeline of return pipe, that is, the main backwater pipeline of the household floor heating distribution main pipe.

The installation method is also relatively simple, mainly using parallel connection, installing two tees on the return pipe of the distribution main pipe and installing a valve between the two tees, so as to ensure that the return water main pipe and the circulating pump can be used independently without interference.

Extended data:

1. At the water separator, the upper water pipe is above and the lower water pipe is below.

2. When heating in winter, the upper water pipe is hot and the lower water pipe is cold.

3. At the water separator, there is a filter at the water inlet point of the upper water pipe. The pipes here are different.

When purchasing a floor heating circulating pump, we mainly look at two data of the circulating pump, the first is power, and the second is lift. First of all, when it comes to power, of course, the bigger the better, but if you live in a flat-topped house around 100㎡, you can only choose the basic model around 150W, and you should choose the corresponding equivalent power according to the specific area of your house. The bigger the house, the greater the power.