What are the precautions for herringbone flooring?

If you want to make the word floor more perfect, pay attention to these points.

1, herringbone spelling means front and back buttons. Generally, the factory packaging is put in a bag, with the front and back half. Don't take it all out when you shop. Try to lay one bag first, and then lay the next one.

2. When the shop is stuck, you should also leave enough shrinkage joints. Although the herringbone splicing board is small and has many joints, it is not easy to deform and deform the tiles than the general conventional board, and the shrinkage joints should be left.

3. The requirements of herringbone and fishbone flooring for the flatness of the ground are that the horizontal height difference within 2m is not more than 3mm. ..

4. The loss of herringbone spelling is greater. When calculating the loss, the loss ratio should be at least 1. 1.

5. After leveling the cement floor, it is recommended to do a self-leveling. Self-leveling is less than 5mm, and a layer of cement slurry is enough. The cost will not be high, but it can prolong the service life of the floor. The height of the stone crystal floor is 5-8mm, and the height between the floor and the door should be well controlled.

6. Without self-leveling, the bricklayer's workmanship is not good, and the cement floor will be pitted. After installing the floor, I found that many places under the floor were empty. The floor shook, so I had to tear it down and start over.

7. Check the flatness of the floor before laying the floor. Many times, the installer will not tell you that the floor is uneven, he will install the floor directly. Therefore, if you want to buy a floor with guaranteed brand quality, the staff will come to the door to measure the flatness of the floor. This step cannot be saved.

8. The height is the ground construction in the early stage, which should be taken into account, so that the floor and tiles or thresholds can be unscrupulously on a horizontal line in the later stage, which will be more beautiful visually!

If you really can't be on a horizontal line, it doesn't matter. Seal the edge with a bevel edge sealing strip.

9. Door trim. If the threshold is at the same height as the floor, you can use a thin layering to give people a more delicate feeling. Still depends on the situation on the spot.

10, herringbone really doesn't need to build its own store. It may cost a little more to hire a master, but opening a herringbone 10 store is complicated, and the cost of wasting materials may be more expensive than hiring a master.

Pay special attention to these three points:

1. The loss should be at least 1: 1. What do you mean? That is, we used to use 10 board, and now we use 1 1 board. If there are many corners at home, even more.

2. Choose brand floor, please believe that you get what you pay for. Be sure to measure the flatness of the ground before installing the blank house. It must be. No more than 3mm within two meters. If something goes wrong now to save trouble, you will regret it in a year.

3. If the ground does not meet the standard, it should be self-leveling. Don't save money If the potholes on the ground are not particularly large, it is enough to make them within 5 mm, and the thicker the thickness, the higher the cost.